EGR Eliminators
Remove the EGR for a cleaner look and cooler intake air. The EGR system adds heat and carbon deposits to the intake manifold. EGR Valve Position Sensor Eliminators send a 0.50volt CLOSED EGR signal to the computer. The computer then knows the EGR is permanently closed. Keeps the annoying CHECK ENGINE light OFF, and more importantly keeps the engine running smoothly. Guaranteed to work on any 1986-93 5.0L Mustang! Also works on most 1986-95 Ford that uses the Light Gray EGR valve position sensor; which has a closed reading of 0.24 – 0.67 volts. Without this the computer will assume the EGR is stuck open when removed, causing a rough running engine. We can’t guarantee these will work on every 1986-95 Ford, but the only other option is a custom chip for the computer, which typically costs $350 or more. While the only option for 1996 and newer Fords is a custom tuned chip for the computer.
Made with original Ford parts that plug into your stock wiring harness EGR Position Sensor connector under the hood.
BACK ORDER IS OVER!
We recieved all the parts from Ford to make another batch of 1000
Comes with terminals ready to be inserted into the harness near the computer. Can be hidden near the computer, for a cleaner look!
click for larger picture
75 ohm 3watt Resistors can also be used to eliminate the EVR, CANP, TAB & TAD solenoids.
Fits: 1986-93 5.0L Mustangs, and 1993-95 5.8L Lightnings
Retains the stock throttle cable bracket mounting location
3/8in Thick
Now comes with Gaskets!
Typically for 1986-93 5.0L Mustangs, and 1993-95 5.8L Lightnings. Fits over 300 different vehicles, please measure your EGR mounting surface before ordering.
Now comes with gasket and stainless bolts!
Fits: 1994-95 5.0L Mustangs, 1991-93 5.0L T-Birds, 1984-93 2.3L Fords, and 1985-97 4.9L 5.0L 5.8L & 7.5L Ford Trucks. Please measure your EGR mounting surface before ordering.
Now comes with gasket and stainless bolts!
Typically for most 4.6L engines, fits over 240 different vehicles, please measure your EGR mounting surface before ordering. Now comes with Gasket!
Fits: 5.4L V8 & 6.8L V10 engines, please measure your EGR mounting surface before ordering. Now comes with Gasket!
Fits: 1994-95 5.0L Mustangs, some 4.6L engines, and many other Fords.
Fits: 1986-96 Trucks and many other Fords.
Plug the holes in the back of your cylinder heads when removing the exhaust crossover tube. Comes with 2 plugs and Loctite. Hex head makes installation easy when the engine is still in the vehicle.
NOTE: These are not intended for pollution controlled vehicles. Local, State, and Federal laws may prohibit the removal or disabling any emission control device such as the EGR system.
